NEC Infrared Decoder and Encoder Addon Board

Receives a raw modulated or demodulated NEC IR signal and converts it into bytes that are sent out the serial port. The serial baud rate is selectable from two default speeds. The default usage mode transmits out a command sequence with framing bytes, address high, address low, and the validated command byte. This device is designed to remove the work load of protocol decoding from the main processor, which could be a PIC, Arduino, FTDI, or other similar serial capable device. It supports full duplex communication when using an I.R. transceiver. See the datasheet for full info.

Note: This device will see only limited release, as it is not-cost effective to produce in quantity. Custom ordering is available. Otherwise it is recommened to use the project files and create your own.

Includes:

• 1x NEC Infrared Decoder and Encoder Board
• 1x 5-pin header
• Option to Add:  24-Key Remote Control - With or Without Custom NLED Decal
• Option to Add: TSOP38238 receiver Or TFBS4711 transceiver

Links:

• Device Webpage
• Device Datasheet
• Open-Platform Project Files - GitHub / Download